The Pinch Tube Valve is a compact and cost effective device for dispensing very thin liquids, semi-viscous materials, cyanoacrylates, anaerobics, solvents, UV cure adhesives and two-component fluids. For repeat dots, beads or potting. The only part of the valve that makes contact with the liquid is the low cost replaceable pinch tube assembly.  This makes the TS1212 valve ideal for aggressive or curable liquids with no risk of the material setting and damaging expensive parts.

Compact and easy to set up, this valve is operated by any of our valve controllers. A controller provides a timed pulse of air pressure to open the TS1212 pinch tube, allowing the adhesive or liquid to flow. A spring loaded shut-off provides the ability to make micro dots if required with no drips between shots. The shot size is determined by the time setting on the controller, the amount of opening set on the TS1212 adjustable stroke control and the size of needle tip used. For complete systems, we offer a range of options including TS1212 valve, pressure pot and controller. The connecting link between reservoir and TS1212 is a fluid line that offer a safe luer lock connection and are suitable for use with most liquids and adhesives.  Use Teflon lined or Teflon tips for cyanoacrylates, General Purpose tips for other fluids and Tapered tips for more viscous gels.

Part ID:	TS1212
Size:	83mm L x 40mm Diameter
Weight:	82 g
Wetted Parts:	Polyethylene
Viscosity Range:	1 - 45,000 CPS
Min Shot Size:	0.007 cc/ ml
Repeatability:	±0.56%
Flow Rate:	0.54 GPM @ 60 psi (water)
Max Fluid Pressure:	60 psi ( 4 Bar)
Material Inlet:	Female Luer Lock
Material Outlet:	Male Luer Lock
Mounting:	1/4" 20UNC-2B
On/Off Pressure:	50 psi (3.4 Bar) Minimum
Lead Time:	* Ships in 1-2 Business Days
	Datasheet 60k

Adhesive Dispensing Ltd provide a wide range of equipment options for dispensing almost all assembly fluids - from watery liquids, solvents, primers and activators through to thick pastes, sealants, silicones, gels and epoxies.