A precision dosing valve that uses a needle assembly to dispense precise dots or very fine beads of low to medium viscosity adhesives and fluids such as anaerobics, activators, inks, gels, solvents, lubricants, chemicals and UV's.  Needle seal at tip end prevents dead space for very fast shut off when dispensing micro dots without drips. Suited to repeat deposits, micro dotting of grease, gels, UV cure, solvents and inks.

This needle valve is designed to apply micro shots without drips. The valve design is vertical with fluid flow from the side either by syringe, cartridge or fluid line feed (from pressure pot).  Always use black fluid lines or feed tubing with any UV cure adhesives.

Part ID:	TS5440
Materials:	303 Stainless Steel, Teflon Seals
Size:	5" (127mm) L x 1.10" (28.5mm) Dia.
Weight:	227g (0.5lb)
Viscosity Range:	1 - 100,000 CPS
Repeatability:	±0.3%
Cycle Rate:	Up to 500 cycles/ minute
Flow Rate (water):	900ml/min @ 100 psi
Min Shot Size:	0.003 cc/ ml
Max Fluid Pressure:	300 psi (21 Bar)
Activation Pressure:	70 psi (4.8 bar) minimum
Material Inlet:	1/8" NPT
Material Outlet:	Male Luer Lock
Mounting:	10-32 UNF
Lead Time:	* Ships in 3-4 Business Days

Adhesive Dispensing Ltd provide a wide range of equipment options for dispensing almost all assembly fluids - from watery liquids, solvents, primers and activators through to thick pastes, sealants, silicones, gels and epoxies.